检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:刘伟[1,2] 卢天健[2] 杨冠军[1] 王飞[2] 卢亚峰[1] 毛小南[1] 杜宇[1] 奚正平[1]
机构地区:[1]西北有色金属研究院,陕西西安710016 [2]西安交通大学强度与振动教育部重点实验室,陕西西安710049
出 处:《钛工业进展》2009年第6期15-18,共4页Titanium Industry Progress
基 金:国家科技支撑计划(2007BAE07B01);国家"973"项目(2007CB613807;2006CB601202)
摘 要:研究了CT20低温钛合金管材的加工工艺及冷轧变形量、退火温度对管材力学性能的影响。结果表明:CT20合金对加工硬化不敏感,冷轧最大变形量应控制在45%以内;CT20合金管材通过不同温度热处理所获得的等轴、双态和片状组织的室温力学性能差别不大;20 K低温下由于孪生变形的发生,片状组织的塑性最好,双态组织则介于片状和等轴组织之间;管材为等轴和双态组织时,冷成型性能优异;对管材进行α+β两相区910℃×1 h,FC的热处理,可获得综合性能优良的双态组织。The influence of cold deformation and temperature upon the processing and mechanical properties of CT20 cryogenic titanium alloy tubes is studied experimentally. Obtained results show that the plasticity of the tube is not sensitive to deformation hardening, and the maximum degree of cold deformation should be controlled under the level of 45%. Three different heat treatments are used, resulting in three different microstructures of the alloy: equiaxed, bimodal and lamellar. The alloy with lameUar structure has the best plasticity because of twinning, whilst the one with bimodal structure has the best overall mechanical properties and cold processing ability at cryogenic temperature.
分 类 号:TG335.7[金属学及工艺—金属压力加工]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.145