铸钢表面镍基合金渗层耐磨性能的研究  

Investigation on Wear Resistance of Ni-based Infiltrated Layer on Cast Steel Substrate

作　　者：张巨银[1,2] 杨贵荣[1,2] 马颖[1,2] 王辉[1,2] 

机构地区：[1]兰州理工大学甘肃省有色金属新材料省部共建国家重点实验室,甘肃兰州730050 [2]兰州理工大学有色金属合金省部共建教育部重点实验室,甘肃兰州730050

出　　处：《热加工工艺》2010年第3期62-65,共4页Hot Working Technology

基　　金：甘肃省中俄国际合作项目(4WS064-A72-053);中科院"西部之光"项目(SLK07009)

摘　　要：以提高铸钢表面的耐磨性为目的,用负压铸渗技术在铸钢表面制备了一层与基体结合良好的耐磨镍基合金渗层;对渗层的成份、硬度进行了分析;用MM-200摩擦试验机,对比考察了镍基合金渗层与基体在干滑动摩擦条件下的摩擦磨损性能。结果表明:渗层到基体的显微硬度呈梯度变化,最高硬度出现在亚表层,硬度为542HV;在相同的摩擦条件下渗层的耐磨性远高于基体,载荷为100N时基体的磨损率是渗层的9倍,载荷为250N时基体的磨损率是渗层的5.19倍;渗层的存在提高了材料的耐磨性;渗层的磨损主要受氧化粘着和转移机制的控制。In order to improve the wear resistance of cast steel surface, by negative pressure cast infiltration technology, uniform Ni-based compound wear resistant layer combining with cast steel was gained. The composition and hardness of the layer were analyzed. The wear resistance of both ZG45 and Ni-based coating on ZG45 substrate under dry-lubricated was comparatively investigated with MM-200 friction and wear tester. The results show that the distribution of macro-hardness presents gradient change, the subsurface layer＇s hardness is highest, its is 542 HV. Under the same condition, compared with cast steel, the wear resistance of the layer is greatly superior to ZG45 substrate. When the load is 100 N, the wear rate of cast steel substrate is 9 times that of infiltrated layer, and when the 10ad is 250 N, the wear rate of cast steel substrate becomes 5.19 times that of infiltrated layer. The existence of the layer improves the wear resistance of materials. The wear mechanisms of the coating were dominated by the oxidation, transfer and adhesion on the substrate.

关 键 词：负压铸渗 渗层 干滑动摩擦 

分 类 号：TG174.44[金属学及工艺—金属表面处理]