灰铁轴承衬体铸造工艺模拟与优化  

Numerical Simulation and Optimization of Casting Process for Gray Cast-iron Bearing Liner

作　　者：王有超[1] 董翠粉[1] 米国发[1] 

机构地区：[1]河南理工大学材料科学与工程学院,河南焦作454000

出　　处：《热加工工艺》2010年第5期51-53,共3页Hot Working Technology

基　　金：河南省杰出人才创新基金(0621000700)

摘　　要：利用ViewCast软件对灰铁轴承衬体充型和凝固过程进行了分析,通过凝固过程金属分布模拟了缩孔(松)产生的位置。采用挂砂外冷铁配合冒口使用对原方案进行了优化,最终消除了铸件中的缩孔(松)缺陷。再次模拟结果表明,改进方案合理可行,实现了平稳逐层充型和顺序凝固,从而有效地改善了铸件质量。The mold filling and solidification stages of gray cast-iron bearing liner was analyzed by V-CAST software. The position of the shrinkage was simulated by metal distribution of solidification stage. The chill block hanged sand and the riser were used to optimize the original casting process. Finally the shrinkage of the casting was eliminated. The re-simulated results reveal that the optimized casting process is feasible and carrys out gradually-layered steady filling and sequential solidification. And the quality of castings effectively improve.

关 键 词：轴承衬体 数值模拟 凝固 充型 

分 类 号：TG244.3[金属学及工艺—铸造]