1880压力调宽机砧型的改造研究  

Anvil Improvement of 1880 Slab Sizing Press

作　　者：李俊慧[1] 刘才[1] 董敏[1] 江小军[2] 王向[1] 

机构地区：[1]燕山大学轧机研究所,河北秦皇岛066004 [2]宝山钢铁股份有限公司热轧厂,上海200941

出　　处：《钢铁》2010年第5期57-60,共4页Iron and Steel

摘　　要：针对压力调宽机在轧制连铸坯时出现的夹送辊输送打滑现象,运用有限元软件DEFORM建立某钢厂1880SSP压力调宽机定宽轧制模型。将模拟结果与理论计算对比,找出了打滑的主要原因是"狗骨"变形纵向高度差值过大。通过对砧型3个阶段的研究,提出新的砧型,使生成的"狗骨"变形满足夹送辊输送时的咬入条件,并进行了试验得到了验证。For the phenomenon of skid,which appeared when the slab size press pressed the continuous casting slab,a pressing mode1 for 1880 mm slab sizing press in some steel mill was established on basis of the DEFORM finite element software.Through comparing the stimulated result with the theoretical calculation,it is the key factor that the vertical high differential value of the ＂dog bone＂ is too high.A new kind of anvil is brought forward after researching the three stages of the anvil.The new ＂dog-bone＂ deformation satisfies with the rolled condition in which pinch roll is transporting.It is validated by the modeling experiment finite element.

关 键 词：SSP压力调宽机 “狗骨”变形 砧型 

分 类 号：TG333[金属学及工艺—金属压力加工]