检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]东南大学能源与环境学院
出 处:《建筑热能通风空调》2010年第2期37-40,共4页Building Energy & Environment
基 金:"十一五"国家科技支撑计划基金项目(2008BAJ12B02);江苏省科技支撑计划-工业部分基金项目(BE2009151)
摘 要:研究扁管总数和总流程数一定,扁管分配比例已知的条件下,不同流程间扁管分配布置方式对平流式冷凝器换热性能的影响。采用稳态分布参数法,建立冷凝器换热数学模型。计算典型工况下不同扁管分配布置方式的结果显示:按制冷剂流动方向,依次减少每个流程扁管数的分配布置方式,所得冷凝器换热量和制冷剂出口过冷度相对最大,压降相对最小,冷凝器换热性能相对最优。Effect of tubes distribution on efficiency of parallel-flow type condenser was investigated for a given condition of definite tubes, flow passes and distribution proportion. The simulation model was established with method of steady distributed parameter. The simulation results indicate that the thermal capacity is the largest, the pressure drop is the smallest and the super-cooling degree is the largest by way of decreasing tube numbers of each flow pass along with the refrigerant flowing.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.13