不同石墨形态的铸铁干滑动摩擦学性能研究  

Friction and Wear Characteristics of Cast Iron Under High Speed Dry Sliding Condition

作　　者：黄滢玉[1] 陈跃[1] 高鸣[1] 张永振[1] 

机构地区：[1]河南科技大学材料科学与工程学院,河南洛阳471003

出　　处：《热加工工艺》2010年第10期33-36,共4页Hot Working Technology

基　　金：国家973项目(2007CB607603);河南省创新团队项目;河南省教育厅项目(2008A430006)

摘　　要：在MMs-1G型高速摩擦磨损试验机上对不同石墨形态的铸铁进行高速干滑动摩擦磨损试验。利用SEM观察并分析摩擦面磨损形貌及磨损机理。结果表明:石墨形态对铸铁的摩擦磨损性能有显著影响;随着速度的增加,摩擦系数降低,磨损率增大。The friction and wear characteristics of cast iron with different graphite morphology（dry sliding against GCr15 steel） were investigated on MMS-1G high speed friction and wearing machine under the conditions of velocity（10～90 m/s） and contact load（0.33～1.67 MPa）.The wear mechanisms and tribo-metallographic phases were studied using scanning electron microscopy.The results show that the graphite morphology has an obvious effect on friction and wear characteristics of the cast iron.The friction coefficient declines and wear rate increases with the increase of sliding velocity.

关 键 词：铸铁 高速干滑动 摩擦磨损 

分 类 号：TH117[机械工程—机械设计及理论]