保护膜用压敏胶剥离强度增幅研究  

Study on increasing range of PSA peeling strength for protective film

作　　者：武鹏[1] 冯小平[2] 齐暑华[1] 刘乃亮[1] 毛胜华[2] 李胜华[2] 

机构地区：[1]西北工业大学理学院应用化学系,陕西西安710072 [2]襄樊航天化学动力总公司,湖北襄樊441003

出　　处：《中国胶粘剂》2010年第6期46-49,共4页China Adhesives

摘　　要：采用预乳化半连续聚合法合成了保护膜用乳液型压敏胶(PSA),探讨了单体、乳化剂、引发剂、缓冲剂和交联剂等对乳液型PSA剥离强度增幅的影响。结果表明:乳液型PSA剥离强度增幅随丙烯酸丁酯(BA)或复合乳化剂用量的增加呈先降后升的态势,随丙烯酸(AA)或缓冲剂用量的增加而增大,随苯乙烯(St)、丙烯酸-2-羟丙酯(HPA)或引发剂用量的增加而减小;当w(BA)=85%时,剥离强度增幅最小;大分子有机硅和交联剂的加入能明显降低PSA剥离强度增幅,当w(大分子有机硅)=1.0%时,剥离强度增幅最小;当加入相同用量的交联剂GA240或SC-100时,前者使PSA的剥离强度增幅更低。The emulsion type pressure sensitive adhesive（PSA） for protective film was prepared by pre--emulsified semi-continuous polymerization, the influences of some factors（such as monomer, emulsifier, initiator, buffering agent, cross linker and other factors） were discussed on increasing range of emulsion type PSA peeling strength. The results showed that the increasing range of emulsion type PSA peeling strength had trend of fall-rise with increasing butyl acrylate （BA） or composite emulsifier contents, and had trend of rise with increasing acrylic acid（AA） or buffering agent contents, and had trend of fall with increasing styrene（St）, HPA or initiator contents. The increasing range of peeling strength was least when mass fraction of BA was 85%. The macroinolecular organosilicon and cross linker could obviously debase the increasing range of PSA peeling strength, and the increasing range of peeling strength was least when mass fraction of macromolecular organosilicon was 1.0%. The increasing range of PSA peeling strength with GA240 cross linker was less than with SC-100 cross linker when GA240 contents and SC-100 contents were same.

关 键 词：保护膜 剥离强度 增幅 乳液 压敏胶 大分子有机硅 

分 类 号：TQ436.3[化学工程]