三维套管变形井有限元几何建模研究  

MODELING STUDY ON FINITE ELEMENT FOR THREE-DIMENSION CASING DEFORMATION

作　　者：佘月明[1] 龚得银 

机构地区：[1]中国石化河南油田分公司井下作业处,河南南阳473132 [2]中国石油吐哈油田公司,新疆哈密839009

出　　处：《西南石油大学学报（自然科学版）》2010年第3期172-175,共4页Journal of Southwest Petroleum University(Science & Technology Edition)

基　　金：国家自然科学基金项目(50874095)

摘　　要：套管变形后,在整形前需要有限元分析模拟整形过程,但是其几何建模比较困难。为了解决该问题,定义多臂井径仪测量平面及其法向矢量,在测量平面上建立多臂井径仪的局部坐标系,确定了局部坐标方向的方向余弦矩阵,导出了测量平面上井径仪的测量臂与套管接触点的全局坐标计算公式。根据上述公式,编写程序将计算结果导入ANSYS软件,再通过曲线拟合、蒙皮、拉拔和网格剖分得到了套管变形后有限元模型。利用多臂井径仪实际测量数据进行套管变形后的几何建模,结果表明:所提出的三维套管变形的几何建模方法是可行的,具有较强的实用价值。After 3-D well bore tract deformation,the finite element method should be used to analyze and simulate the reshaping process before reshaping,but geometric modeling is quite difficult.In order to solve the problem,the multi-arm caliper measuring plane and normal vector was defined.On the measuring plane,the local coordinate system for multi-arm caliper is set up,the cosine matrix of local coordinate orientation is determined,and the calculation equation for the while coordinate between casing contact point and caliper on measuring plane is derived.Program is developed and the calculation consequence is input into ANSYS software based on the equation mentioned above,the finite element model after casing deformation is obtained through curve matching,skinning surface,extrusion and griding.The geometric modeling after casing deformation is carried out by using the measured data with multi-arm caliper,and the result indicates the developed geometric modeling method for 3-D casing deformation is feasible and of practical value.

关 键 词：三维 套管 有限元 井径 建模 

分 类 号：TE931[石油与天然气工程—石油机械设备] TE319