悬吊结构体系摆振响应测试及非线性误差修正  

Swing Response Measuring and Nonlinear Error Modification of Suspended Structure System in Pendulum Vibration Mode

作　　者：张春巍[1] 李芦钰[2] 喻言[3] 欧进萍[4,2] 

机构地区：[1]哈尔滨工业大学土木工程学院,哈尔滨150090 [2]大连理工大学土木水利学院,大连116024 [3]大连理工大学微电子研究所,大连116024 [4]哈尔滨工业大学土木工程学院哈尔滨,150090

出　　处：《振动．测试与诊断》2010年第3期227-231,共5页Journal of Vibration,Measurement & Diagnosis

基　　金：国家自然科学基金资助项目(编号:90815027,50608026);国家基础研究发展计划(“九七三”计划)资助项目(编号:2007CB714204)

摘　　要：为解决悬吊结构多种模式摆振运动状态的量测问题,采用基于加速度测量原理的倾角传感器,通过理论分析建立了由传感器加速度信号提取平动运动模式下结构摆角增益系数的计算公式,解决了结构平动运动模式的量测问题,并且经过非线性误差修正后可以提高测量精度。对于结构转动(或回转)运动模式,类似于平动摆振运动控制系统在转动中由于质量振子的线性位移与结构摆角速度耦合影响而导致控制失效的问题,此时基于加速度原理的倾角传感器也将失效,而需要采用陀螺仪测量回转运动摆振角速度,再通过积分计算结构摆角。最后,对悬吊结构体系在两种运动模式下的摆振运动状态测量进行了试验验证,结果充分证明了本文所提方法的有效性和可行性。此外,针对悬吊结构复杂的多模式平转耦联摆振状态测量,提出需要将倾角传感器与陀螺仪相结合的监测策略。In order to solve the state measurement problem of pendulum vibration of a suspended mass system in multi-motion modes,the inclinometer sensors based on acceleration measuring principle are introduced and the formulation of the gain coefficients from the signal of sensor acceleration to structural pendulum angle is established through the theoretical analysis,which can be used to solve the measurement of planar motion of the system.Furthermore,after nonlinear modifications,the measurement results can reach a high precision.While,similar to the motion control problem,the acceleration-based inclinometer sensor will lose its effectiveness owing to the gyrus motion mode of the suspended structure, and the gyroscope is needed to measure the angular velocity,then the pendulum angle is acquired through mathematical integration calculations.At last,the two motion modes of the suspended mass system are both measured through experimental verifications,the results of which soundly prove the feasibility and accuracy of the measuring method proposed in this paper.In addition,for the complicated planar and rotary coupled motion modes,the inclinometer and the gyroscope should be integrated together to measure the pendulum motion state of the suspended mass system.

关 键 词：摆角测量 平动运动 转动运动 非线性误差修正 平转耦联运动 悬吊结构 

分 类 号：TU313.3[建筑科学—结构工程] TB123[理学—工程力学]