ITER Side校正场线圈端部大圆弧模压成形及回弹分析  

Molding and Spring-Back Effect Analysis for Large Arc of ITER Side Correction Coils

作　　者：文伟[1] 吴杰峰[1] 陈文革[2] 夏世波[1] 李波[1] 

机构地区：[1]中国科学院等离子体物理研究所,安徽合肥230031 [2]中国科学院强磁场科学中心,安徽合肥230031

出　　处：《原子能科学技术》2010年第7期836-840,共5页Atomic Energy Science and Technology

基　　金：国家科技计划ITER计划专项资助(国内配套研究)(2008GB101000)

摘　　要：利用大型有限元分析软件ANSYS分析了国际热核实验反应堆(ITER)Side校正场线圈(CC)端部三维大圆弧模压成形及释放模具后导体的回弹效应,研究了不同半径成形时导体内外表面的应力、应变的分布及释放模具后导体的回弹规律。设计了1套模压成形模具,通过修模的方式在该套成形模具上进行了不同半径成形试验,测得了不同成形半径时模压成形后的回弹量值。试验结果验证了所建立的有限元分析模型的正确性。有限元分析和试验结果表明:ITERSideCC端部三维大圆弧可通过模压成形达到所需的大半径要求,为ITER Side CC端部三维大圆弧成形提供了一种可行方案。A finite element analysis（FEM）simulation model for large arc of International Thermonuclear Experimental Reactor（ITER）Side correction coils by molding was established.Processes including molding and spring-back effect after being molded were simulated.The distribution of stress,strain on the inner and outer faces of conductor were gained,and the value of spring-back after being molded was obtained.One set of molding equipment was designed and manufactured,and the value of spring-back with molds of different radiuses by using this equipment was obtained.The experimental results show that the FEM simulation model is correct and molding is a feasible method for the manufacturing of ITER Side correction coils.

关 键 词：ITER Side校正场线圈 模压成形 回弹 有限元分析 

分 类 号：TB121[理学—工程力学]