微电解法预处理亚麻生产废水试验研究  

Pretreatment of wastewater from flax production by miro-electrolysis process

作　　者：刘娟娟[1] 单长青[1] 

机构地区：[1]滨州学院城市与环境系,山东滨州256603

出　　处：《工业用水与废水》2010年第4期39-42,共4页Industrial Water & Wastewater

基　　金：滨州学院青年人才创新工程(BZXYQNLG200708)

摘　　要：采用铁炭微电解工艺对亚麻生产废水进行预处理。探讨了填料种类、pH值、反应时间对微电解法去除CODCr的影响。试验结果表明:在铁炭质量比为1,进水pH值为3.0,反应时间为3 h,采用曝气方式,Ca(OH)2投加量为1.5 g/L的条件下,CODCr去除率可达31.8%左右,可生化性由0.21提高到0.47,为后续生化处理创造了有利条件。Micro-electrolysis process was used to pretreat wastewater from flax production.The influences of filling material,pH value and reaction time on CODCr removal were investigated.The results of the test showed that： when the iron-carbon mass ratio was 1,the influent pH value was 3.0,the reaction time was 3 h,the Ca（OH）2 dosage was 1.5 g/L,using aeration method,the removal rate of CODCr could reach about 31.8%,the biodegradability increased from 0.21 to 0.47,which provided favorable condition for the subsequent biochemical treatment.

关 键 词：微电解 亚麻废水 正交试验 可生化性 

分 类 号：X798.031[环境科学与工程—环境工程]