检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:侯伟宏[1] 张沛超[1] 胡炎[1] 苏永春[2]
机构地区:[1]上海交通大学电气工程系,上海200240 [2]江西省电力科学研究院,江西南昌330096
出 处:《电力系统保护与控制》2010年第18期44-48,53,共6页Power System Protection and Control
基 金:国家自然科学基金项目(50807037)~~
摘 要:随着基于IEC 61850的数字化变电站系统的进一步发展,传统变电站内的信号和控制电缆将逐步被过程总线所代替。IEC已经将工作重心逐渐转移到过程总线上,结合制订IEC 61850 Ed 2.0,IEC开始深入研究并制订诸如IEC 62439-3、IEEE1588-2008等标准。阐述了IEC 62439-3标准的典型技术特征,及其支持网络无扰恢复的技术原理。将IEC 62439-3应用于过程总线,并与传统保护系统相比,分析采用不同过程总线的全数字化保护系统的结构,利用可靠性框图对不同结构的保护系统可靠性参数进行详细的计算和分析。针对过程层总线宜采用的网络结构给出了建议。With the further development of the substation automation system based on IEC 61850, the process bus will be widely used in the substation to replace the traditional signal and control cable. IEC has shifted its focus to the process bus. Combined with the formulation of IEC 61850 Ed 2.0, IEC begins to study and develops some standards such as IEC 62439-3, IEEE 1588-2008, etc. This paper describes the typical technical characteristics oflEC 62439-3 standard, and introduces the main technical principles of the network bumpless recovery. It applies IEC 62439-3 to the process bus. By comparing with the traditional protection system, the paper analyzes alternative all-digital protection systems which employs different process bus architectures. Finally, the reliability block diagrams are used to calculate and analyze the reliability indices of different protection systems, and network structure that fits for nrocess bus is pronosed.
关 键 词:IEC 61850 IEC 62439-3 并行冗余协议 高可用无缝环 保护系统 可靠性
分 类 号:TM774[电气工程—电力系统及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.249