检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:俞彦勤[1] 黄早文[1] 何小诚 王少力[2] 程鹏[2]
机构地区:[1]华中理工大学 [2]胜利石油管理局工程机械厂
出 处:《石油机械》1999年第4期42-45,共4页China Petroleum Machinery
摘 要:根据两端约束的厚壁圆管轴向受压时的变形特点,建立了运动学许可的速度场及应变速率场;应用金属塑性成形的上限理论,计算了管坯变形时的各项功率及管坯镦锻时的单位变形力,并确定了变形时的最佳工艺参数。厚壁管镦锻时,为节约动力,减少材料消耗和提高模具寿命,应减小管坯与模具(特别是与凹模)之间的摩擦;管坯镦锻成形法兰时高度系数a大于或等于临界值a0时,管坯变形处于稳定状态,若a<a0,则管子产生内壁凹陷或折叠;对给定的管坯初始尺寸系数b而言,应尽量减小管坯与凹模间的摩擦,适当增大管坯与心轴间的摩擦。Based on the characteristics of deformation of thickwalled circular pipe under axial pressure,relevant velocity field and strain rate field are established.By using the upperbound theory,the deformation powers and unit deformation force in upsetting are calculated,and the optimal technological parameters are determined.In upsetting of thickwalled tube,to save power and decrease material consumption and improve die life,measures should be adopted to reduce the friction between the tubebillet and the die(especially the cavity die),and the coefficient of the flange height a should be not less than the critical value a0. If a<a0, depression or folding of the tube's inwall will be resulted.By increasing properly the friction between the tubebillet and the mandrel,the amplitude of billet deformation can be enlarged without producing deformation faults.
分 类 号:TG311[金属学及工艺—金属压力加工] TE9[石油与天然气工程—石油机械设备]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222