检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]电力系统仿真控制教育部重点实验室(天津大学),天津市南开区300072
出 处:《中国电机工程学报》2010年第28期66-71,共6页Proceedings of the CSEE
基 金:国家自然科学基金项目(50607014)~~
摘 要:高压输电线路距离继电器受故障点过渡电阻以及负荷电流的影响,可能出现误动的现象。分析推导了在相间故障情况下相间距离继电器的测量阻抗,研究了线路负荷电流对阻抗继电器动作特性的影响。指出重载线路末端发生相间故障的情况下,位于送电侧的超前相的相间距离继电器存在误动的可能,位于受电侧的滞后相的相间距离继电器存在误动的可能。最后提出了相间距离继电器的改进措施。大量仿真测试与现场故障实例验证了理论分析的正确性以及所提方法的有效性。The distance relay of transmission line may real-operate due to the influence of fault transit resistance and load current. The paper deduces measurement impedance expressions of phase-to-phase distance relay in the case of phase-to-phase faults. Based on the deduced expression of measurement impedance, the paper analyzes the influence of load current on distance relay, and then indicates that phase-to-phase distance relay of the leading phase at the sending end is possible to mal-operate when the transmission line is heavily loaded and the phase-to-phase fault occurs at the end of the transmission line, while the distance relay of the lagging phase at the receiving side may mal-operate. Eventually, the paper proposes the measure to improve the distance relay. Simulation tests and real fault record verify that the theoretical analysis and improved methods are correct and valid.
关 键 词:电力系统 距离保护 相问故障 误动 余弦电压 元件
分 类 号:TM77[电气工程—电力系统及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.15