分流桥宽度对挤压成形的影响及模具应力分析  

Influence of shunting bridge width to extrusion process of aluminum alloy tubes and moulds stress analysis

作　　者：庞祖高[1] 韦春萍[1] 雷声远[1] 韦健 

机构地区：[1]广西大学材料科学与工程学院,广西南宁530004 [2]广西南南铝业股份有限公司,广西南宁530031

出　　处：《锻压技术》2010年第5期137-141,共5页Forging & Stamping Technology

基　　金：广西自然科学基金项目(2010GXNSFA013020)

摘　　要：针对铝型材分流组合模中分流桥的宽度对挤压成形的影响,采用Deform-3D有限元软件对15,20,25 mm这3种不同分流桥宽度下的3003铝合金圆管挤压过程进行数值模拟,得到了挤压力、应力等物理场量的变化规律。模拟结果表明,分流桥宽度为25 mm时,应力分布最均匀,流速均衡性最好;20 mm时,模具的应力集中分布区域最小。模拟结果为模具结构的合理设计提供理论指导。Aiming at the influence of shunting bridge width of aluminum porthole die to extrusion process,the extrusion process for three kinds of shunting bridge width（15,20,25mm）of 3003 aluminum alloy tubes were simulated by using Deform-3D software.The changes and distributions of the physical variables,such as extrusion load and stress were gained.Simulation results show that the stress distribution is evenest and the uniform flow velocity is best when the shunting bridge width is 25mm;when it is 20 mm,the regional distribution of mould＇s stress concentration is minimum.Simulation results provide a theoretical guidance for mould design.

关 键 词：分流桥 挤压成形 数值模拟 应力分析 

分 类 号：TG375.41[金属学及工艺—金属压力加工]