圆捆机成型室的试验与研究  

Experiment and Research on Forming Box of Wound Bundler

作　　者：杜韧[1] 张晗[1] 李丹 

机构地区：[1]北华航天工业学院,河北廊坊065000 [2]呼伦贝尔市特种设备检验所,内蒙古呼伦贝尔市021008

出　　处：《北华航天工业学院学报》2010年第5期1-3,共3页Journal of North China Institute of Aerospace Engineering

基　　金：河北省教育厅基金项目(2008406)

摘　　要：结合圆捆机的结构特点分析了成型室的成捆原理,着重研究了钢辊式圆捆机的成型室,提出了实际应用中存在的问题。针对液压系统压力高和卷制的圆草捆密度低的现状,提出了成型室改进设计方案。通过对比试验证明,改进后的成型室把圆捆机液压系统的压力降低1/3以上,同时提高了卷制圆草捆的密度。Structural characteristics of wound bundler machine and principles of forming chamber into a bundle are analyzed. Problems in the practical application are presented in a focused study of the steel roll forming machine room. For the high system pressure of hydraulic system and volume low - density system, an improved program of forming chamber is proposed. The comparative test shows that the round bundle of hydraulic system pressure has been reduced 1 / 3 or more and the density of rolling round bales has been increased by the improved molding of forming chamber.

关 键 词：圆捆机 成型室 圆草捆 捡拾器 

分 类 号：S817.115[农业科学—畜牧学]