检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:矫维成[1] 王荣国[1] 刘文博[1] 杨帆[1]
机构地区:[1]哈尔滨工业大学复合材料与结构研究所,哈尔滨150001
出 处:《复合材料学报》2010年第5期116-121,共6页Acta Materiae Compositae Sinica
基 金:国家自然科学基金(90916008)
摘 要:本研究的目的是建立一种用来预测纤维缠绕复合材料压力容器封头厚度的方法。针对固化成型的复合材料压力容器封头型面,基于封头段所有缠绕纱带总体积保持不变条件,提出了一种采用三次样条函数来预测复合材料压力容器封头厚度的方法。采用该方法对具有不同几何尺寸、不同缠绕工艺参数的复合材料压力容器进行了封头厚度预测,并与传统预测方法及实际厚度测量值作了对比分析。算例结果表明,该方法能够比传统方法更准确地预测纤维缠绕复合材料压力容器的封头厚度,从而为有限元建模分析提供精确的厚度参数。This research aims to establish a method to predict the dome thickness of composite pressure vessels.According to the dome shape of cured composite pressure vessels,a cubic spline function was presented to predict the dome thickness based on the volume of all fiber tows being constant.Using this method,the dome thickness of an arbitrary composite pressure vessel with different geometrical parameters and process parameters was forecasted.The predictive results were compared with the traditional methods and actual measured thickness.The results show that dome thickness obtained from the cubic spline function could reflect actual measured thickness better than the other methods and it could provide more accurate thickness parameters for the finite element modeling.
分 类 号:TB332[一般工业技术—材料科学与工程] TB330.1
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.249