微发泡PP/竹塑复合材料发泡行为及性能研究  

Study of Foaming Behavior and Mechanics Properties on Microfoam PP/Bamboo Flour Composites

作　　者：赵武学[1,2] 何力[2] 朱艳[2] 贾仕奎[2] 龚维[2,3] 

机构地区：[1]贵州大学化学与化工学院,贵州贵阳550003 [2]国家复合改性聚合物材料工程技术研究中心,贵州贵阳550014 [3]贵州师范大学材料与建筑工程学院,贵州贵阳550014

出　　处：《塑料科技》2010年第11期49-52,共4页Plastics Science and Technology

基　　金：国家重点基础研究发展计划(973)资助(2007CB616912)

摘　　要：采用注塑成型方法,在二次开模条件下制备微发泡聚丙烯(PP)/竹粉复合材料,分析了不同含量的竹粉对微发泡PP复合材料力学性能和发泡行为的影响。结果表明:随着竹粉用量的增加,泡孔平均直径逐渐减小,泡孔密度逐渐增加。竹粉用量为30%时,泡孔直径最小,为23.4μm,泡孔密度达到10.4×106个/cm3,具有理想的发泡效果。竹粉用量在20%时,发泡材料的冲击强度和纯PP基本相同,在性能不降低情况下,节约了原材料成本。The microcellular foam PP/bamboo flour composites was prepared under the condition of twice-open mold by injection method. The effects of different content bamboo flour on the mechanical properties and foaming behavior of microcellular foam PP composites were analyzed. The results show that with the increase of bamboo flour content,cell diameter decreases gradually,cell density increases gradually. The cell diameter is 23.4μm and cell density reaches to 10.4×106 cells/cm3,when the content of bamboo flour is 30%,there is an ideal foaming effects in microcellular foam composites; when the content of bamboo flour is 20%,the impact strength of the foam composites and pure PP is basically the same. Under the condition of not reducing the mechanical properties of composites,the cost of raw material is saved.

关 键 词：聚丙烯 竹粉 发泡行为 力学性能 

分 类 号：TQ325.14[化学工程—合成树脂塑料工业]