检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:闫成至[1] 李尚远[1] 郑小平[1] 张汉一[1]
机构地区:[1]清华大学电子工程系信息技术国家实验室集成光电子学国家重点实验室,北京100084
出 处:《光电子.激光》2010年第12期1813-1816,共4页Journal of Optoelectronics·Laser
基 金:国家"973"计划资助项目(2006CB302805);国家自然科学基金资助项目(60736003)
摘 要:对相位敏感型低相干光干涉(OLCR)法延时测量系统进行了理论分析,建立了相关数学模型,搭建了基于非平衡迈克尔逊干涉仪的OLCR测量装置,以掺铒光纤放大器(EDFA)自发宽谱光作光源,对光子晶体光纤(PCF)延时(1540~1560nm)进行测量,取得0.14ps左右的测量精度。利用该系统测量光学元件参数,多采用元件末端面反射光与参考光干涉,但对光纤等器件的延时参数进行测量时,利用透射光会更加方便。The principle of time delay measurement system using phase-sensitive optical low-coherence reflectometry(OLCR) is analyzed and the mathematic model is given.The measurement system based on non equilibrium Michelson interferometer is established,using ASE broadband light of EDFA as the source,and the time delay of photonic crystal fiber from 1540 nm to 1560 nm is measured with accuracy about 0.14 ps.In OLCR system,the reflected light from the end face of optical device is commonly used for interference with reference light.However,for the time delay measurement of fiber and so on,the transmission light is a more convenient choice,as shown in this paper.
关 键 词:相位敏感 低相干光干涉(OLCR) 延时 光子晶体光纤(PCF)
分 类 号:TN247[电子电信—物理电子学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222