检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:魏克新[1] 杜吉飞[1] 于洋[1] 纪世忠[1]
机构地区:[1]天津理工大学,天津市复杂工业系统控制理论及应用重点实验室,天津300384
出 处:《电力电子技术》2010年第12期116-118,共3页Power Electronics
基 金:国家自然科学基金项目(50977063);国家863高技术研究发展计划项目(2008AA11A145);天津市科技支撑重点项目(09ZCKFGX01800)~~
摘 要:在实际三相整流器实验中,一般用采样频率来限制开关频率,设定滞环来减少谐波含量。滞环宽度过小不但会增大开关频率,而且会因谐波的不平衡性使网侧功率因数减小。分析了滞环宽度影响网侧谐波的原因,并在综合考虑三相电流的情况下,提出采样频率固定时计算最小滞环宽度的方法。最终通过仿真和实验验证了该方法的正确性,可以在最小滞环宽度下提高谐波电流的平衡性,使系统功率因数达到最佳值。In the actual three-phase rectifier experiment,sampling frequency is generally used to limit the switching frequency,the hysteresis width is set to reduce the harmonic content.If the hysteresis width is too small,it will in-crease the switching frequency and make the power factor decrease due to the imbalance of network harmonic.This paper analyzes the principle that hysteresis width affect AC-side harmonic and put forward a method to calculate minimum hysteresis width in fixed sampling frequency based comprehensive consideration of three-phase current situ-ation.Finally Matlab simulation and low power experimental results verify the correctness of this method,the minimum hysteresis width improves the balance of harmonic current,power factor of the system achieves the best value.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.145