压力容器分析设计的塑性分析方法  

Plastic Analysis Methods for Design by Analysis of Pressure Vessels

作　　者：陆明万[1] 寿比南[2] 杨国义[2] 

机构地区：[1]清华大学工程力学系,北京100084 [2]中国特种设备检测研究院,北京100013

出　　处：《压力容器》2011年第1期33-39,共7页Pressure Vessel Technology

摘　　要：以ASMEⅧ-2 2007版为主线,结合欧盟标准EN 13445 2002介绍和评论压力容器分析设计的塑性分析方法,包括ASME的极限载荷分析方法、弹塑性应力分析方法和欧盟的直接方法等。Plastic analysis methods for design by analysis of pressure vessels are introduced and reviewed in this paper. The ASME VIH -2 2007 is taken as the mainline of the introduction, and the European standard EN 13445 2002 is also involved. The limit- load analysis method and elastic -plastic stress analysis method of ASME Code, as well as the direct route of European standard are included in this introduction.

关 键 词：极限载荷分析 弹塑性分析 直接方法 压力容器分析设计 

分 类 号：T-651[一般工业技术] TB125[理学—工程力学]