检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]华侨大学机电及自动化学院,福建泉州362021
出 处:《华侨大学学报(自然科学版)》2011年第2期130-134,共5页Journal of Huaqiao University(Natural Science)
基 金:福建省自然科学基金资助项目(E0810040);福建省青年创新基金资助项目(2004J033)
摘 要:运用田口实验设计方法,模拟分析不同工艺参数组合下的收缩变形,研究不同工艺参数对非球面塑料光学透镜平均体积收缩率的影响程度.分析结果表明,保压压力、填充时间、熔体温度和浇口尺寸对塑件平均体积收缩率有显著的影响,且影响程度依次降低.正交实验得出其最优化的工艺参数组合:模具温度为45℃、熔体温度为250℃、保压压力为25 MPa、填充时间为6.2 s、保压时间为13 s、冷却时间为38 s和浇口尺寸(宽×深)为3 mm×2 mm.最后,选取保压压力、填充时间、熔体温度和浇口尺寸进行有交互作用的正交试验,结果显示4个参数之间的交互作用对非球面塑料光学透镜的平均体积收缩率影响较小.Using Taguchi method of experimental design,shrinkage deformation of injection product under different compages of process parameters is simulated and analyzed to study degrees of different process parameters′ effects on average volumetric shrinkage of aspherical plastic optical lens.It can be concluded from analysis results that,effects of packing pressure,injection time,melt temperature and gate sizes on average volumetric shrinkage of products are prominent,the effect degree of which decreases in turn.And the results of orthogonal experiment have shown that,optimum process parameters are: mold temperature is 45 ℃,melt temperature is 250 ℃,packing pressure is 25 MPa,filling time is 6.2 s,packing time is 13 s,cooling time is 38 s and sizes of gate(width and depth) are 3 mm×2 mm.In the end,packing pressure,injection time,melt temperature and gate sizes are selected to conduct orthogonal experiments considering interaction,results have shown that interaction effects between these four process parameters on average volumetric shrinkage of aspherical plastic optical lens are smaller.
关 键 词:非球面塑料光学透镜 田口实验 工艺参数 平均体积收缩率
分 类 号:TQ320.661[化学工程—合成树脂塑料工业]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222