钢制变齿厚平面蜗轮副的研制  

Research on Trial-manufacture of Steel-steel Gradual-change Tooth Thickness Planar Worm Gear Drive

作　　者：邱昕洋[1] 秦大同[1] 张光辉[1] 

机构地区：[1]重庆大学机械传动国家重点实验室,重庆400030

出　　处：《四川大学学报（工程科学版）》2011年第2期222-227,共6页Journal of Sichuan University (Engineering Science Edition)

基　　金：国家自然科学基金资助项目(50075089)

摘　　要：在阐述平面包络环面蜗杆成型原理基础上,深入分析了虚拟回转中心原理,并应用该原理加工了蜗杆齿面。在THM63100Ⅳ上磨削了平面蜗轮齿面。检测了蜗轮的几何误差,并应用FMT系统测试了蜗轮副的传动误差。通过装配实践,考察了蜗轮副的齿侧间隙和接触斑。结果表明:平面蜗轮精度达5级(GB/T 10089—88);蜗轮副传动平稳;齿侧间隙调整到0.003～0.025 mm范围内;接触斑与理论接触区吻合良好。结果表明,蜗轮和蜗杆齿面均可硬化处理并能用简单方法实现磨削加工,可制造精度高;沿轴向移动调整蜗轮即可实现蜗轮副齿侧间隙的合理调整;钢制变齿厚平面蜗轮传动性能更全面,值得深入研究并广泛推广。Based on the engagement theory of the planar envelopment hourglass worm,the principle of dummy gyration center was analyzed and applied to machining the worm.The planar worm gear were finished on the THM63100Ⅳ.Machining error of worm gear was tested and transmission error of worm gears was measured by the motion property testing and analyzing system（FMT）.Bachlash was adjusted and contact marks were observed during assembling.The results of error detection showed that the accuracy of wormgear is up to 5 degree in china GB 10095—88 and the worm gears drives smoothly.The results of assembly showed that backlash is adjusted successfully in the range of 0.003~0.025 mm and contact marks are consistent with theoretical contact zones.It was concluded that the harding teeth surface of planar worm gear and its worm can be ground simply and the backlash of worm gears can be adjusted easily.

关 键 词：磨削蜗轮 虚拟回转中心原理 装配 误差分析 

分 类 号：TH132.4[机械工程—机械制造及自动化] TG115.6[金属学及工艺—物理冶金]