EVA热熔胶的制备及其在衬塑复合钢管中的应用  

Preparation of EVA hot melts adhesives and their application in plastic-lined steel pipes

作　　者：文巍伟 高利 张亭亭 

机构地区：[1]广东联塑科技实业有限公司,广东佛山528318

出　　处：《粘接》2011年第5期70-72,共3页Adhesion

摘　　要：以EVA树脂为主体,采用挤出造粒工艺制备衬塑复合钢管用热熔胶。采用正交试验法优选出EVA热熔胶的最佳配方,结果表明,选用VA质量分数为28%、MI为3g/10min的EVA树脂,m(EVA)∶m(松香)∶m(PE蜡)=100∶50∶30时,EVA热熔胶对金属和塑料的粘接剪切强度最高。由此热熔胶制得的衬塑复合钢管,各项性能指标都达到CJ/T136—2007标准要求。Using EVA resin as the basic component,an EVA hot melt adhesive for plastic-lined steel pipes was prepared by extruding.The optimal EVA hot melt adhesive formulation was obtained by orthogonal experiment method.The results showed that when the EVA with VA content 28% and MI 3 g/10min was used,and the m（EVA）：m（rosin）：m（PE wax） was 100 ： 50 ： 30,the shearing strength of adhesive to plastic-lined steel pipes reached the maximum,Moreover,using the EVA hot melt adhesive steel pipes of lining plastic,the properties of obtained plastic-lined steel pipes can meet the standard requirements ofCl/T 136--2007.

关 键 词：EVA热熔胶 正交试验 衬塑复合钢管 应用 

分 类 号：TQ436.4[化学工程]