基于Proteus的自动拨号报警器仿真设计  

Simulation Design of an Auto-dial Annunciator Based on Proteus

作　　者：吴文忠[1] 

机构地区：[1]广东金融学院实验教学中心,广东广州510521

出　　处：《现代电子技术》2011年第10期55-58,共4页Modern Electronics Technique

基　　金：广东省科技计划项目(2009B010800040)

摘　　要：利用嵌入式系统仿真软件Proteus实现了基于AT89C51单片机的自动拨号报警器仿真设计。详细分析自动拨号报警器的硬件设计原理,并在Keil开发环境下设计了对应的驱动程序,在Proteus中完成了软、硬件的联合仿真调试,最后给出了仿真运行结果。通过Proteus软件的前期仿真,大大缩短了实际开发周期,降低开发成本,对于单片机应用系统、电子电路的开发和教学等都有较大的实用价值,且设计的电路及驱动程序对相应的实际应用系统具有一定的借鉴作用。The simulation design of auto-dial annunciator based on AT89C51 microcontroller was realized with an embedded system simulation software Proteus. The hardware design principle about the auto-dial annuneiator is analyzed in detail, the corresponding driver is designed in the Keil development environment, and then the software / hardware co simulation and debugging are completed in Proteus system. The simulation results are given. The actual development cycle and the develop- ment cost are significantly reduced through the pre-simulation with Proteus software, which is feasible to MCU system design, circuitry exploitation and teaching. In addition, the circuit and driver plays a certain reference role in the corresponding practical application system.

关 键 词：PROTEUS 自动拨号报警器 仿真设计 驱动程序 

分 类 号：TN911-34[电子电信—通信与信息系统] TP368.2[电子电信—信息与通信工程]