检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]湘潭大学机械工程学院,湖南湘潭411105 [2]湘潭大学材料与光电物理学院,湖南湘潭411105
出 处:《材料工程》2011年第4期89-93,共5页Journal of Materials Engineering
基 金:湖南省自然科学基金资助项目(10JJ6078);湘潭大学科研启动基金资助项目(06QDZ0509QDZ16)
摘 要:采用药芯焊丝埋弧堆焊方法制备含有0.1~1.0 C,4~13 Cr,2.5~3.2 V,2.2~3.8 B(质量分数/%)的过共晶高硼合金。借助光学显微镜、扫描电镜、X射线衍射等手段,研究其显微组织及硼化物分布形貌。结果表明:显微组织由铁素体+马氏体+残余奥氏体+M2B+M3(B,C)+V2C等组成,其初生M2B相的数量随硼含量而改变。此外,考察碳含量对高硼堆焊合金硬度及耐磨粒磨损性能的影响,实验表明,高硼堆焊合金硬度HRC高达66.5,耐磨性优良,随着碳含量增加,硬度和相对耐磨性ε先升高,然后下降,其磨损机制从磨粒的显微切削逐渐转变为微观断裂和显微切削共存。Hypereutectic high-boron hardfacing alloys containing 0.1-1.0 C,4-13 Cr,2.5-3.2 V,2.2-3.8 B(mass fraction/%) were deposited by using submerged arc welding(SAW) flux-cored wire.The microstructure and boride morphology were investigated by optical microscopy(OM),scanning electron microscopy(SEM) and X-ray diffraction(XRD).The microstructure consists of ferrite,martensite,residual austenite,borides and carbide such as M2B,M3(B,C),V2C,etc.The volume fraction of primary boride M2B varied with boron content.In addition,the effects of carbon content on hardness and wear properties of high-boron hardfacing alloys were evaluated.The results showed that the hardness value was up to HRC 66.5 and the abrasion resistance was excellent.With the increased of carbon concentration,both the hardness and abrasion resistance firstly enhanced,and then decreased.The wear mechanism changed from abrasive particle micro-cutting to micro-area spalling together with micro-cutting.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222