检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
出 处:《电力学报》2011年第3期181-185,共5页Journal of Electric Power
摘 要:平衡变换系统是同相牵引供电系统实现的核心设备,因此其保护工作显得尤其重要。针对同相供电实现的基本要求,分析了平衡变换系统的基本工作原理,并研究其运行过程中系统功率流通情况,首次提出了基于有功功率差动的平衡变换系统保护方案。利用Matlab/Simulink对平衡变换系统正常运行及区内外故障等工况进行仿真,仿真结果证明,基于有功功率差动的同相供电平衡变换系统保护方案是可行的。Because of the Balance-converting-device's(BCD) importance for the cophase traction power supply system,the protection for the BCD is essential.Considering of the special demands of the cophase traction supply system,this paper analyzes the operation principle of the BCD and researches it's power flow.A novel protection based on the active power differential is proposed.Simulation with Matlab/Simulink is presented under the BCD's normal and inside/outside fault operation.The simulation result shows that the protection based on the active power differential is feasible.
关 键 词:继电保护 牵引供电系统 同相供电 平衡变换 有功功率差动 保护
分 类 号:TM714[电气工程—电力系统及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.117

