检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]江苏省电力公司,江苏南京210024 [2]南京理工大学自动化学院,江苏南京210094 [3]南京南瑞集团公司,江苏南京210003 [4]南通供电公司,江苏南通226400
出 处:《电工电气》2011年第6期11-14,共4页Electrotechnics Electric
摘 要:分析了一种利用输电线路双端电气量进行精确故障定位的测距方法,该方法采用输电线路的分布参数模型,将线路故障看为正常运行状态和故障附加状态的叠加,基于等效序网,通过对称分量法求得故障附加状态下的各序故障分量,利用负序故障分量(三相对称故障采用正序故障分量)进行故障测距。在算法实现的关键环节分析了全波傅氏滤波算法。利用MATLAB仿真结果表明,该方法不严格要求线路两端数据同步采样,测距结果几乎不受线路负荷、故障点过渡电阻及故障合闸角等因素的影响,有较高的测距精度,具有较高的工程实用价值。Analysis was made to a kind of distance measuring method to locate fault accurately using transmission line two-terminal electrical quantities.This method adopted distributed parameter model of transmission line,the fault state divided into normal operation and fault additional state.Based on transmission line's equivalent sequence network,the fault components of every sequence at the fault additional state were got through symmetrical component method.The negative sequence fault components(positive sequence fault components for three-phase symmetrical fault) were used to realize fault location.And full-wave Fourier algorithm was analyzed at the key tache.Simulation results in Matlab show that the data needed in the method is not strictly required synchronous sampling,and the fault location results are independent of the following factors,such as pre-fault line load,transition resistance and fault initial angle etc.The method can locate fault site precisely and has high practical value.
分 类 号:TM855[电气工程—高电压与绝缘技术]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.38