检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]华侨大学脆性材料加工技术教育部工程研究中心,厦门361021
出 处:《金刚石与磨料磨具工程》2011年第3期1-4,10,共5页Diamond & Abrasives Engineering
基 金:国家自然科学基金资助项目(50825505;50975099);教育部新世纪优秀人才支持计划资助项目(NCET-08-0610);福建省高等学校新世纪优秀人才支持计划资助项目(07FJRC04)
摘 要:利用六个激光位移传感器对锯切加工花岗石过程中串珠绳的振动进行跟踪,利用MATLAB软件分析采集来的振动信号,从频率和幅值两个方面来研究锯切过程对串珠绳振动的影响。试验结果表明,串珠绳在非切削过程中的振动信号含有多个主频率,但是进入切削过程后,其主要振动频率为串珠的冲击频率。切削过程的振动信号幅值比非切削过程中振动信号的振动幅值要小,随着进给速度和线速度的增加,串珠绳的振动幅度减小。Six laser displacement sensors are used to track the vibration of diamond wire saw while it is sawing granite.MATLAB software is used to analyze the vibration signal data.Frequency and amplitude are used to illustrate the influence of cutting process on the vibration of diamond wire saw.The test results show that vibration signal of diamond wire saw consists of multiple frequencies when it is in non-cutting state.But when the diamond wire saw comes into the cutting process,the vibration frequency is only in an impacting mode.The amplitude of vibration in cutting process is lower than in non-cutting process.The vibration amplitude of diamond wire saw decreases with the increase of feeding speed and linear velocity.
分 类 号:TQ164[化学工程—高温制品工业] TG74[金属学及工艺—刀具与模具]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.15