检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]中国科学技术大学电子工程与信息科学系安徽省光电子科学与技术重点实验室,合肥230027
出 处:《光电工程》2011年第7期17-24,共8页Opto-Electronic Engineering
摘 要:针对天文光谱观测系统使用的传光光纤在布放和观测过程中因弯曲和入射中心未对准光纤中心而导致的焦比退化效应,采用光学追迹方法进行了分析计算。根据我国大天区面积多目标光纤光谱望远镜(LAMOST)工程中实际使用的光纤光缆的参数,分析并计算了所用传光光纤的使用条件,为工程应用提供参考。根据分析计算的结果,在LAMOST工程中光纤对准误差设计值为不大于32μm的条件下,LAMOST工程中光纤光缆施工安装及观测使用过程中最小弯曲半径应限制在不小于300mm。Ray tracing was used to analyze the Focal Ratio Degradation (FRD) properties of fibers, which is caused by the light transmitting in the fibers with offset and bending when we set the fibers and observe stars in astronomy. We analyzed and calculated the conditions of the fibers used in the Large Sky Area Multi-Object Fiber Spectroscopy Telescope (LAMOST) according to the parameters of the fiber cables used in the LAMOST. These works provide useful reference in this project. According to the analysis and computation, the designed aim error of fibers should be less than 32 μm at least. The least bending radii is 300 mm when the fibers are installed for observation in the LAMOST projection.
分 类 号:TN252[电子电信—物理电子学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.28