高密度脉冲电流对服役后期高锰钢辙叉组织结构的影响  

Effect of High Current Density Electropulsing on the Microstructure of Later-Serviced High Manganese Steel Crossing

作　　者：杨志南[1] 张明[1] 张福成[1] 冯晓勇[1] 

机构地区：[1]燕山大学亚稳材料制备科学与技术国家重点实验室,秦皇岛066004

出　　处：《材料研究学报》2011年第4期342-346,共5页Chinese Journal of Materials Research

基　　金：国家杰出青年科学基金50925522;国家自然科学基金50871094;国家自然科学创新群体研究科学基金5082100;河北省杰出青年基金E2009001632;国家重点基础研究发展计划2010CB731606资助项目~~

摘　　要：用高密度脉冲电流对服役后期的高锰钢辙叉进行表面处理,研究了对其组织结构的影响。结果表明,在较低的温度下(786 K)辙叉发生再结晶,再结晶晶粒尺寸约为29.3μm,远比处理前的晶粒尺寸小,处理后的显微硬度显著降低。在高密度脉冲电流作用下,位错运动能力、原子的扩散能力以及振动频率都提高了,从而使再结晶的形核速率显著提高,使辙叉在较低的温度下快速完成再结晶。处理后高锰钢的疲劳寿命显著提高。A kind of high current density electropulsing treatment was carried out on the surface of later-serviced high manganese steel crossing.The results show that specimen finished recrystallization at a relatively low temperature of 786K,the recrystallization grain size of～29.3μm was much finer than that of the specimen before treatment,and the microhardness decreased remarkably after treatment by high current density electropulsing.Electropulsing enhanced the recrystallization nucleation rate of the specimen which resulted in recrystallization being finished at low temperature rapidly.Enhancement of the nucleation rate mainly resulted from the increase in mobility of dislocation、diffusion ability of atoms and the frequency of the atoms.The fatigue life of high manganese steel was improved notably after treatment by high current density electropulsing.

关 键 词：金属材料 再结晶 脉冲电流 高锰钢辙叉 

分 类 号：TG142[一般工业技术—材料科学与工程]