不锈钢表面处理对Cr_2O_3薄膜太阳能选择吸收性能的影响  

Effect of Stainless Steel Surface Treatment on Properties of Solar Selective Absorption Cr_2O_3 Films

作　　者：王珂[1] 李光磊[1] 马涛[1] 王涛[1] 黄伟[1] 万倩[1] 王辉[1] 程旭东[1] 

机构地区：[1]武汉理工大学材料复合新技术国家重点实验室,武汉430070

出　　处：《材料导报》2011年第16期116-118,131,共4页Materials Reports

基　　金：国家高技术研究发展863计划(2009AA052440)

摘　　要：采用Sol-gel法以及浸渍提拉法在不锈钢表面制备了Cr2O3选择性吸收薄膜。分别采用喷砂处理和氧化液腐蚀两种方式对不锈钢进行表面处理,考察不同表面处理方式对Cr2O3太阳能选择吸收薄膜性能的影响。用Lambda 750型UV-Vis-NIR分光光度计和Tensor 27型BRUKER红外光谱仪分别测试薄膜在可见-近红外光谱区和红外光谱区的反射光谱。结果表明,氧化液处理的不锈钢基体,其表面所涂覆薄膜的红外发射率明显降低,发射率由喷砂基体的0.465降低到0.186,具有良好的选择吸收性。Solar selective Cr2O3 absorber was made by sol-gel method on stainless steel. Two different ways were used on surface treatment of stainless steel. One was blasting and the other was the use of liquid oxide corrosion. Film＇s spectral reflectivity curves in UV-Vis and far infrared spectra were measured by spectrophotometer Lambda 750 UV-Vis-NIR and infrared spectrometer of Tensor 27 BRUKER separately. The calculated results show that corroded film＇s solar emissivity is lower from 0. 465 to 0. 186 than that of sand-blasted. The results indicate that the corroded film show better performance of selectivity.

关 键 词：太阳能选择吸收 溶胶-凝胶法 不锈钢表面处理 红外反射 CR2O3 

分 类 号：TK-9[动力工程及工程热物理]