检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:沈显杰[1] 张文仁[1] 杨淑贞[1] 管烨[2] 金旭[3]
机构地区:[1]中国科学院地质研究所 [2]中国地质科学院岩石圈研究中心 [3]长春地质学院
出 处:《地球学报》1990年第2期203-214,共12页Acta Geoscientica Sinica
摘 要:本文首先报道大地热流剖面测量的系统成果,进而分析南北剖面的热流分布特征及其构造热演化意义;在此基础上,结合南北各地体不同的构造变形环境所诱发的深部热作用和放射性生热、摩擦应变生热和深部热流分量等热源组分在配置上的差异,分区论述青藏高原北部、中部和南部3种不同类型的地壳—上地幔热结构。The average thickness of the crust reaches 70 km in the Qinghai-Xizang Plateau, meanwhile the surface hydrothermal manifestations are widespread over the Himalayan Geothermal Belt. In addition, high heat flow was observed in South-Xizang, and the DSS, gravity and magnetic survey, as well as MTS all unanimously revealed a series of geophysical features of a warm crust. This compatibility of a thick yet warm crust in the Qinghai-Xizang Plateau fully evidenced geophysically has been once again proved by a N-S heat flow profile study, reflecting not only the peculiarity of the crust-mantle thermal structure, but also the close genetic relation between the deep-seated formation process of such a specific thermal structure and the tectono-dymanic environment. Thus, the first step was forwarded towards the study on the unitary thermo- tectonic evolution of the Qinghai-Xizang Plate au. The N-S heat flow profile consists of the following 13 study areas :Pum-uyiong Lake(n = 5, q=91 mW/m2), Yangzhuoyiong Lake(n=4, q=146mW/m2), Luobusha(q=60mW/m2), Northern Suburb of Lhasa(q = 66mW/m2), Maqu(q = 106mW/m2), Yanbajing(q = 108mW/m2), Yangyingxiang(q = 364mW/m2), Ladu-ogang(q=338mW/m2), Naqu(q = 319mW/m2), Lunbula(n = 2, 9 = 140mW/m2), Tuotuohe(q = 47mW/m2), Northern Foothill of Kunlun Mts. (q = 42mW/m2), and Xitieshan(q = 42mW/m2). The heat flow distribution pattern is noted with:(l)heat flow highs in South and lows in North, (2)stable in North and fluctuating in South, and(3)low heat flow belt affiliated to the Yarlung-Za-ngbo Suture Zone of bordering significance among the anomalously high heat flow regions in the south. Based on this pattern and considering the forms and boundary conditions of deformations and the heat source patterns (including shear-heating) of the different terranes, the whole Qinghai-Xizang Plateau can be divided into three parts:( 1 )cold united block of the four old terranes in north with, thick crust-thick lithosphere structure, (2) enormously squized-shortened hot Lhasa-Gangdise Terrane in the middle
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.117