检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]吉林大学长春电信工程设计院股份有限公司,长春130012 [2]中国联通吉林省分公司网管中心,长春130021 [3]长春理工大学图书馆,长春130022
出 处:《吉林大学学报(信息科学版)》2011年第4期311-319,共9页Journal of Jilin University(Information Science Edition)
摘 要:为使广大通信工作者能对新版(2002年)通信工程勘察设计收费标准正常应用,指出通信工程勘察设计收费国家标准中勘察和设计两个收费标准表中都缺少内插值;而设计收费标准表中既没有界定计费额度范围,工程计费额度范围与收费基价的对应关系又不明确,因此无法进行正常的计算。为此,研究了收费标准的客观规律,界定计费额的范围,确定计费额范围与收费基价的对应关系,计算各段的内插值,补充和完善收费标准。举例说明了勘察设计费的具体计算方法。In order to make the large numbers of communication works use the 2002 edition survey and design charging standards of communication engineering normally,we introduces the national survey and design charging standards of communication engineering in which interpolation is not concluded;neither definition of charges range nor clear correspondence between the amount of engineering charging and charge benchmark was included in design charging standard sheet,which made it difficult to calculate the charging.Aiming at solving the above problems,we did the following study: the objective law of charges,definition of the amount of charging,correspondence between the amount of engineering charging and charge benchmark,interpolation calculation of each section,supplement and improvement of the charge standards.Finally the paper briefly introduces a specific calculation method for survey and design charging.
分 类 号:TN913[电子电信—通信与信息系统]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.140.242.43