基于光固化快速成型技术的测压风洞模型孔道制造与性能评价  

Fabrication and Performance Evaluation of Micro-channels in Aircraft Wind-tunnel-models for Pressure Measurements Using Stereolithography

作　　者：张威[1] 李涤尘[1] 赵星磊[1] 朱伟军[1] 王炜[2] 刘钧[2] 

机构地区：[1]西安交通大学机械制造系统工程国家重点实验室,陕西西安710049 [2]中航工业集团成都飞机设计研究所,四川成都610041

出　　处：《航空学报》2011年第12期2335-2340,共6页Acta Aeronautica et Astronautica Sinica

基　　金：国家自然科学基金(51075385);成都飞机设计研究所基金~~

摘　　要：传统金属加工制造测压风洞模型存在难度大、周期长、成本高的问题,利用光固化快速成型技术,可以实现测压风洞模型气动外形-内部孔道的一体化成型制造。设计制作了不同孔径、长度的孔道结构模型,对孔道成型质量和孔道结构参数之间以及孔道半径与设计半径之间的关系进行了研究,并对孔道的气密性以及通气性进行了验证。研究得出了可成型的测压模型孔道结构包括孔径、流道长度以及成型方向3个参数的设计原则以确保孔道成型后能够导通。另外,建立了不同孔径大小的设计补偿原则以减小快速成型制造误差。研究表明,测压孔道气密性、通气性均良好,基于光固化快速成型的一体化测压模型制造技术满足风洞试验要求,可以替代传统模型的测压金属管应用于实际风洞测压试验。In order to overcome the difficulties with machining the internal channels of a wind tunnel aircraft model for pressure measurements,this paper proposes the use of stereolithography to realize the integrated forming of aerodynamic configurations and internal channels.A series of micro-channels with different diameters and lengths are fabricated,and their forming qualities are examined with an optical microscope system.The diameters of cross-sections are also measured to conform with the radius compensation principle concerning the parameters such as diameter,length and prototyping direction.Air tightness and air permeability of the micro-channels is verified by means of a special test device.Therefore,the channels based on stereolithography meet the requirements of wind tunnel test and they are able to replace the metal tubes.

关 键 词：光固化快速成型 风洞试验 测压模型 气密性 通气性 

分 类 号：V261.7[航空宇航科学与技术—航空宇航制造工程]