薄板型腔高压充型行为的水流与计算机模拟  

Experiments and computer simulation for thin plate mould filling in high pressure with flowing water

作　　者：王越[1] 尚丽娟[1] 刘正[1] 赵慧杰 李峰 赵忠俭[1] 

机构地区：[1]沈阳工业大学材料科学与工程学院,辽宁沈阳110023

出　　处：《沈阳工业大学学报》1999年第6期491-494,共4页Journal of Shenyang University of Technology

摘　　要：应用Ｆｌｏｗ３Ｄ软件对高压水流快速充型的过程进行了计算机模拟，并在相同条件下采用１０００～２０００帧／ｓ照片的高速摄影方法，对着色高速水流在透明的丙烯酸玻璃为材料制成的模具薄板型腔中的充型过程进行了拍摄，二者结果一致．显示了计算机模拟方法研究流体高压充型行为的可行性．应用同样的计算机模拟方法探讨了几种情况下的浇口、溢流槽、型腔形状与位置对其充型行为的影响．其结果对高压铸造铝、镁合金工艺参数设计具有重要参考意义．Through applying the program flow3D, the simulation for the process of mould filling hasbeen made with flowing water at high pressure and speed. The filling prccers of colored flowing waterwere filmed in the thin plate shipped die, which was made from acrylic glass, with a high speed camera taking between 1000～2000 pictures per sec ond on the same condition. The results show goodcoincident, andproved that computer simulation is feasible to study the mould-filling behavior athigh pressure. The influence of the geometry and position of gate, overflows, die cavity on themould filling process was discussed on the different conditions by the means of simulationThe results haveimportant significance to the process parameters, design of aluminum and magnesiumin the high-pressure die-casting.

关 键 词：压力铸造 充型 高压 水流 计算机模拟 薄板型腔 

分 类 号：TG249.2[金属学及工艺—铸造]