热焊工艺对焊接残余应力影响的数值模拟  

Numerical Simulation on Influence of Hot Welding Process on Welding Residual Stress

作　　者：付建科[1,2] 卢泽民[1,2] 徐亮[1,2] 黄晓辉[1,2] 

机构地区：[1]三峡大学水电机械设备设计与维护湖北省重点实验室,湖北宜昌443002 [2]三峡大学机械与材料学院,湖北宜昌443002

出　　处：《热加工工艺》2011年第23期158-160,163,共4页Hot Working Technology

基　　金：水电机械设备设计与维护湖北省重点实验室开放基金项目(2010KJX02)

摘　　要：运用有限元分析软件ANSYS,对25钢对接接头分别在20、200、400、600和800℃的热焊工艺条件下进行焊接残余应力场的数值模拟。通过单元生死技术模拟焊缝的填充过程,得到了其对接接头试板分别在该五种热焊工艺条件下焊接残余应力的大小及分布,并对计算结果进行了分析。结果表明:热焊工艺的加热温度越高,焊后产生的残余应力越小;残余应力降低的幅度在加热温度为400和600℃较明显。By finite element analysis software ANSYS, the effect of welding residual stress field on the. magnitude and distribution of welding residual stress of the 25# welded plates at 20℃ ,200℃ ,400℃ ,600℃ and 800℃ were studied. The magnitude and distribution of 25# welding residual stress under five different heat welding process conditions was obtained by simulating the filling process of the welding with the ＂element birth and death＂ technology. The results show that the heat welding process of heating temperature is higher, the residual stress produced after welding is smaller. The residual stress reduction at 400℃ and 600℃ is very obvious.

关 键 词：热焊工艺 残余应力 有限元法 数值模拟 

分 类 号：TG404[金属学及工艺—焊接]