高体分SiC_p/Al复合材料螺纹性能的测试  

Characteristic test of threads on high volume fraction SiC_p/Al composites

作　　者：刘炳强[1,2] 李景林[1] 王书新[1,2] 高明辉[1] 孙斌[1] 伞兵[1] 

机构地区：[1]中国科学院长春光学精密机械与物理研究所,吉林长春130033 [2]中国科学院研究生院,北京100039

出　　处：《中国光学》2011年第6期576-582,共7页Chinese Optics

基　　金：国家863高技术研究发展计划资助项目(No.863-2-5-1-13b)

摘　　要：从SiCp/Al复合材料性能分析着手,讨论了预置件法、焊接法和粘接法等在空间遥感器研制中常用的联接方法的优缺点,提出了在高体积分数(体分)SiCp/Al复合材料上直接加工螺纹,并加装钢丝螺套的方法来改善螺纹联接性能。对在某高体分SiCp/Al复合材料上加工的M4、M5螺纹进行了拉伸测试,结果表明:加装钢丝螺套前,复合材料螺纹有被拉脱现象;加装钢丝螺套后,M4螺纹、螺杆在3 000～4 000 N被拉断;M5螺纹、螺杆在8 000～9 000 N被拉断,测试后两种规格的螺纹状态良好,可以满足实际应用对该材料拉伸强度的要求,其已应用于工程项目中。Based on analysis of properties of SiCp/Al composites,the advantages and disadvantages of common connecting methods for space optical sensors such as fore-imbedding,welding and bonding were demonstrated.A new method of machining threads directly on high volume fraction SiCp/Al composites and mounting steel wire thread sleeves to improve the thread connection was proposed.The tensile test for M4 and M5 threads on high volume fraction SiCp/Al composites were performed.Obtained results suggest that some of them are pulled out before mounting the steel wire thread sleeve.However,M4 and M5 screws are pulled off under 3 000-4 000 N and 8 000-9 000 N,respectively,after mounting the steel wire thread sleeve.The M4 and M5 threads show good shapes,which means that machining threads directly on high volume fraction SiCp/Al composites and mounting the steel wire can meet the requirements of the engineering for tensile strength and it is already used in some projects.

关 键 词：高体分SiCp/Al材料 复合材料-金属联接 复合材料螺纹 螺纹拉伸强度 

分 类 号：V257[一般工业技术—材料科学与工程] V243.5[航空宇航科学与技术—航空宇航制造工程]