铝合金半固态流变压铸过程数值模拟及试验验证  

Numerical Simulation on Rheocasting of Aluminum Alloy and Experimental Verification

作　　者：唐景[1] 董选普[1] 张磊[1] 潘璋[1] 王文俊[1] 樊自田[1] 

机构地区：[1]华中科技大学材料成形及模具技术国家重点实验室,湖北武汉430074

出　　处：《铸造》2012年第1期51-56,共6页Foundry

基　　金：国家自然科学基金(50775085);中央高校基本科研业务费专项基金(M2009061);国防创新基金(09-3)

摘　　要：采用模拟软件对Al-Si合金半固态流变压铸的充型和凝固过程进行模拟,并与试验进行了对比。结果表明,浇注温度为610℃、压射速度为90 mm/s、料柄及内浇口直径为40 mm时,半固态压铸的卷气以及缩凹缺陷明显减少。同时,通过对温度场的模拟分析,得出铸件的边缘部位与中部具有不同的凝固速度和微观组织,经过试验观测,证明了实验结果与模拟结果的一致性,为铝合金半固态流变压铸的工艺参数拟定和模具设计提供了借鉴。The filling and solidification processes of rheocasting of semisolid aluminum alloy and the temperature field were simulated with a commercial software and then verified by experiments. The results show that air entrapment and depression defects are significantly reduced when the pouring temperature is 610℃, the injection speed is 90 mm/s and the diameter of the ingate is 40mm. Besides, analysis on the simulation result of the temperature field shows that both the cooling rate and microstructure are different at the edge and the center of the workpiece. The simulated result was consistent with the experimental result, which can be reference for the process parameters selection and mold design of rheocasting of semisolid aluminum alloys.

关 键 词：半固态压铸 数值模拟 卷气 缩凹缺陷 微观组织 

分 类 号：TG292[金属学及工艺—铸造]