富氧顶吹熔融还原冶炼高磷铁矿与钛铁矿配矿的试验研究  

Investigation of Iron Smelting With High-Phosphorus Iron Ore and Ilmenite by Oxygen Enriched Top-Blown Smelting Reduction

作　　者：李慧斌[1] 王华[1] 郈亚丽[1] 胡建杭[1] 李幼灵[1,2] 

机构地区：[1]昆明理工大学冶金节能减排教育部工程研究中心,云南昆明650093 [2]昆明钢铁股份有限公司,云南安宁650302

出　　处：《钢铁》2012年第1期19-23,39,共6页Iron and Steel

基　　金：云南省自然科学基金资助项目(2009ZC014M)

摘　　要：采用模拟HIsmelt的富氧顶吹熔融还原技术冶炼惠民高磷铁矿与勐桥钛铁矿配矿,在温度为1 500K,碱度为1.3,配碳比为1.0的条件下,恒温时间20min(在升温过程中,没有通入惰性气体),恒温过程中通入O2(流量250L/h、纯度为99%)10min。恒温时间结束后,调整氧气流量为5L/h,保持其氧化性气氛至冷却。研究了不同配矿比例对铁回收率、生铁中磷、硫含量以及磷、硫分配比的影响。研究结果表明,在惠民铁矿和勐桥精矿的比例为1∶1时,其冶炼结果比较理想:铁的回收率为95.1%,生铁中磷的质量分数约为0.32%,硫的质量分数为0.054%,钛的质量分数为0.031%。Huimin high-phosphorus iron ore and ilmenite from Yunnan province was smelted by oxygen enriched top- blown smelting reduction iron-making technology. Much more details, such as iron recovery rate, distribution ratio of phosphorus and sulfur were discussed. Iron recovery could reach 95% with phosphorus content about 0.32%, sulfur content 0. 054% and titanium content 0. 031% in pig iron produced, under the conditions of 20min holding time at 1500 K, basicity R of 1.3, C/O mole ratio of 1.0 and oxygen enriched flow rate of 250 L/h and ore blending ratio of 1 ： 1. Oxidizing potential of top-space of SRV and slag combination can create the driving force to partition phosphorous and titanium to the slag, which ensure the success of the experiment.

关 键 词：HISMELT 熔融还原 高磷铁矿 钛铁矿 

分 类 号：TF64[冶金工程—钢铁冶金]