Shot noise analysis on corrosion behavior of zinc alloy (ZnAl4Cul) under dry-wet cycles  被引量:3

基于散粒噪声理论分析锌合金(ZnAl4Cul)在干湿循环下的腐蚀行为(英文)

在线阅读下载全文

作  者:CHEN An-na CAO Fa-he LIU Wen-juan ZHENG Li-yun ZHANG Zhao ZHANG Jian-qing CAO Chu-nan 陈安娜;曹发和;刘文娟;郑利云;张昭;张鉴清;曹楚南(浙江大学化学系,杭州310027;中国科学院金属研究所金属腐蚀与防护国家重点实验室,沈阳110016)

机构地区:[1]Department of Chemistry,Zhejiang University,Hangzhou 310027,China [2]State Key Laboratory for Corrosion and Protection,Institute of Metal Research,Chinese Academy of Sciences,Shenyang 110016,China

出  处:《Transactions of Nonferrous Metals Society of China》2012年第1期228-240,共13页中国有色金属学报(英文版)

基  金:Projects (51131005, 51171172, J0830413) supported by the National Natural Science Foundation of China;Project (Y4110074) supported by Zhejiang Provincial Natural Science Foundation, China

摘  要:The corrosion behaviors of zinc alloy (ZnAl4Cul) in 3.5% (mass fraction) NaCl, 7.3% (mass fraction) Na2SO4 and simulated acid rain solutions were investigated using electrochemical measurements. The potential noise during dry-wet cycle was monitored and analyzed by fast Fourier transform (FFT), fast wavelet transform (FWT), shot noise theory and stochastic theory. Cumulative probability curves of event frequency fn indicate that the corrosion events in the dry cycles are greater than those in the wet cycles. Uniform corrosion was observed in the NaCl solution compared with more localized corrosion in the Na2SO4 solution, which is evidenced by FWT and SEM. Conditional events generation rate r(t) for diffusion controlled reactions decreases with increasing the time. r(t) values for uniform corrosion and diffusion controlled process are the largest in the wet cycle in 3.5% NaCl solution. The values of r(t) for pitting corrosion in Na2SO4 solution are observed to become large during spraying periods, and r(t) for pitting corrosion has the largest value in the Na2SO4 solution. The intergranular corrosion of zinc is serious in simulated acid rain solution.采用电化学噪声理论,研究锌合金(ZnAl4Cul)在3.5%(质量分数)NaCl,7.3%(质量分数)Na2SO4和模拟酸雨溶液中干湿循环条件下的腐蚀行为。采用快速傅里叶变换(FFT)、快速小波变换(FWT)和散粒噪声理论结合统计方法分析原位电化学电位噪声。散粒噪声分析的fn累计曲线图表明,在干循环中电子转移事件的频率高于湿循环中的,在NaCl溶液中的腐蚀比在Na2SO4中的腐蚀更均匀,腐蚀事件的条件产生速率r(t)对于受扩散控制的事件来说随着干湿循环时间的延长而降低。锌合金在NaCl溶液中湿循环时,均匀腐蚀和扩散控制的事件的r(t)值最大;在Na2SO4溶液中湿循环时,点蚀事件的r(t)值最大。在酸雨溶液中可明显观察到锌合金的晶间腐蚀。

关 键 词:electrochemical noise shot noise analysis dry-wet cycle zinc alloy 

分 类 号:TG172.8[金属学及工艺—金属表面处理]

 

参考文献:

正在载入数据...

 

二级参考文献:

正在载入数据...

 

耦合文献:

正在载入数据...

 

引证文献:

正在载入数据...

 

二级引证文献:

正在载入数据...

 

同被引文献:

正在载入数据...

 

相关期刊文献:

正在载入数据...

相关的主题
相关的作者对象
相关的机构对象