不同热处理介质对聚氨酯系中空纤维膜性能的影响  

Effect of different hot-treatment media on the properties of polyurethane based hollow fiber membrane

作　　者：刘海亮[1] 肖长发[1] 胡晓宇[1] 刘美甜[1] 

机构地区：[1]天津工业大学中空纤维膜材料与膜过程省部共建国家重点实验室培育基地,天津300387

出　　处：《天津工业大学学报》2012年第1期6-8,16,共4页Journal of Tiangong University

基　　金：国家自然科学基金(20874073);天津市科技计划项目(10SYSYJC27900)

摘　　要：采用熔融纺丝制得聚氨酯系中空纤维膜,研究了不同热处理介质对膜性能的影响.结果表明:所制得的聚氨酯系中空纤维膜经热水介质处理后水通量随理论拉伸倍数的增加而增大,经热空气介质处理后水通量随理论拉伸倍数的增加先增大后减小;经热水介质处理后可提高聚氨酯系中空纤维膜断裂伸长率,而经热空气处理后则可提高其断裂强度;在相同压力条件下,热水介质处理后聚氨酯系中空纤维膜的水通量更易于稳定.Polyurethane （PU） based hollow fiber membranes were prepared by melt-spinning method, and the iniluences of different hot-treatment media on the properties of PU based hollow fiber membranes were studied. The results show that with the increasing in theoretical draw ratio, the pure water flux （PWF） increased by hot-water treatment, but increased and then decreased by hot-air treatment. The PU based hollow fiber membrane treated by hot-water can improve the breaking elongation rate, but can improve the fracture strength treated by hot-air. In the same testing pressure, the PU based hollow fiber membrane treated by hot-water is easier to achieve stability than that treated by hot-air.

关 键 词：聚氨酯 中空纤维膜 热处理介质 

分 类 号：TS102.54[轻工技术与工程—纺织工程] TQ323.8[轻工技术与工程—纺织科学与工程]