苯乙烯臭氧化一步法合成苯甲醛  

One-step Synthesis of Benzaldehyde from Styrene by Ozonolysis Reaction

作　　者：刘慧[1] 梁政勇[1] 章亚东[1] 

机构地区：[1]郑州大学化工与能源学院,河南郑州450001

出　　处：《精细化工》2012年第3期303-307,共5页Fine Chemicals

摘　　要：采用水或有机胺捕获苯乙烯臭氧化生成的两性离子,不经臭氧化物中间体及传统的还原分解反应一步法合成苯甲醛。考察了溶剂种类、溶剂用量、反应温度、臭氧流量和添加剂种类对反应的影响。结果表明,水捕获两性离子的活性大于有机胺,不同有机胺的反应活性不同,其活性大小顺序为:三乙胺>三正丁胺>三正辛胺,叔胺>仲胺。较佳的反应条件(以0.05 mol苯乙烯计)为:溶剂丙酮25.0 mL,反应温度0～5℃,臭氧流量200mL/min,n(水)/n(苯乙烯)=3。在该条件下,重复实验3次,所得苯甲醛的平均收率为96.5%。Carbonyl oxides（zwitterions） are the most reactive intermediates in ozonolysis reaction. This paper describes the trapping of carbonyl oxides by amines or H20,and the subsequent direct ozonolytic conversion of styrene into benzaldehyde without the intermediacy of 1,2,4-trioxolanes （ozonides） and the traditional reduction decomposition. The effects of the type of solvent, amount of solvent, reaction temperature,the flow of ozone and the kind of additive were investigated. The results show that H20 gives better reactivity than amines, and that the reactivity of different amines descends in the order： Et3N 〉 Bu3N 〉 （ CsHl7 ）3N, tertiary amine 〉 secondary amine. The appropriate reaction conditions are as follows （based on 0. 05 mol styrene） ：25.0 mL acetone as solvent, reaction temperature 0 - 5 ℃, the flow of ozone 200 mL/min, n （ H2 O）/n （styrene） = 3. Under the above conditions, the average yield of benzaldehyde is about 96.5 %

关 键 词：苯乙烯 臭氧化 苯甲醛 两性离子 精细化工中间体 

分 类 号：TQ244.1[化学工程—有机化工]