检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:贺毅强[1]
出 处:《复合材料学报》2012年第2期109-114,共6页Acta Materiae Compositae Sinica
基 金:国家自然科学基金(51004050);淮海工学院人才引进科研启动基金(KQ09028)
摘 要:采用多层喷射沉积工艺制备SiCP/Al-8.5Fe-1.3V-1.7Si复合材料,研究了雾化及沉积工艺参数对沉积坯状态及SiC颗粒捕获的影响。结果表明,液流直径大、雾化气体压力小、喷射高度小会导致沉积坯组织恶化,反之则造成收得率低、致密度低。雾化器扫描不均匀则会造成沉积坯形状不均匀,而且会由于热量集中导致显微组织恶化。SiC颗粒输送压力的提高有利于SiC颗粒的捕获以及颗粒的均匀分布。多层喷射沉积制备SiCP/Al-8.5Fe-1.3V-1.7Si的优化工艺参数为:液流直径3.6mm,雾化气体压力0.8MPa,喷射高度200mm,SiC颗粒输送压力0.5MPa。沉积坯存在两种SiC-Al界面:晶态Si界面层与非晶态SiO2界面层。Effects of the atomization and deposition processing parameters on SiCP/Al-8.5Fe-1.3V-1.7Si composites deposit prepared by multi-layer spray deposition were investigated,and effects of the processing parameter on the capture of SiC particles were also studied.The results show that big flow diameter,low atomization pressure and low spray height result in weak microstructure,while small flow diameter,high atomization pressure and big spray height result in low collection ratio and low density.Non-uniform scanning of atomizer leads to non-uniform deposit and coarse microstructure.High feed pressure of SiC particles is beneficial to the capture and uniform distribution of SiC particles.The optimized processing parameters of multi-layer spray deposited SiCP/Al-8.5Fe-1.3V-1.7Si composites are: flow diameter of 3.6 mm,atomization pressure of 0.8 MPa,spray height of 200 mm,and SiC particle feed pressure of 0.5 MPa.SiC-Al interface of crastalline Si and amorphous SiO2 are found in the deposit.
分 类 号:TB331[一般工业技术—材料科学与工程] TG146.2[金属学及工艺—金属材料]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.43