原位CuYSi颗粒增强块体镁基非晶合金复合材料的研究  

Study on in situ CuYSi particle reinforced bulk Mg-based amorphous alloy matrix composites

作　　者：邵阳[1] 陈刚[1] 赵玉涛[1] 张振亚[1] 侯文胜[1] 

机构地区：[1]江苏大学材料科学与工程学院,江苏镇江212013

出　　处：《功能材料》2012年第8期1012-1015,共4页Journal of Functional Materials

基　　金：江苏省高校自然科学研究重大资助项目(10KJA430008);江苏高校优势学科建设工程项目;江苏大学"拔尖人才工程"项目的大力资助

摘　　要：用Mg-4%Si合金、纯Cu、纯Mg、Cu-38%Y合金经普通铜模铸造方法制备了一种原位颗粒增强Mg60Cu30Y10块体非晶合金复合材料。运用XRD以及EDS确定其颗粒为CuYSi相,采用SEM-EDS对颗粒的形貌、大小及成分进行了分析,并对Mg60Cu30Y10块体非晶合金复合材料的硬度及热稳定性进行了研究。结果表明,原位生成的CuYSi颗粒尺寸细小(10μm左右),形状规整并且均匀分布在非晶合金基体上;与Mg60Cu30Y10块体非晶合金相比,CuYSi颗粒的生成使得非晶合金复合材料的硬度增加102.5HV,ΔTx增加6.1K。By traditional copper casting method, a kind of in situ particle reinforced bulk Mg60 Cu30 Y10 amorphous alloy matrix composite was prepared from Mg-Si（4%） alloy, pure Cu, pure Mg and Cu-Y（38%） alloy. Particles in the amorphous alloy matrix composite were determined as CuYSi by XRD and EDS. The morphology, size and composition of the particles were analysised by SEM-EDS. Hardness and thermal stability of the bulk Mg60Cu30Y10 amorphous alloy matrix composite were studied. The results show that the in situ synthesized crystalline CuYSi particles with small size uniformly distribute in the amorphous alloy matrix composite. Compared with pure Mg60Cu30Y10 amorphous alloy, the hardness increased 102.5HV, the △Tx of the composite increased 6.1K.

关 键 词：块体镁基非晶合金复合材料 原位合成 CuYSi颗粒 Mg60Cu30Y10块体非晶 

分 类 号：TG139.8[一般工业技术—材料科学与工程] TG146.22[金属学及工艺—合金]