模具钢Cr12电火花线切割加工工艺试验研究  

Experimental Research on WEDM Process of Tool Steel Cr12

作　　者：赵灵[1] 郭光宜[1] 周升[1] 

机构地区：[1]南通职业大学机械学院,江苏南通226007

出　　处：《电加工与模具》2012年第2期59-60,62,共3页Electromachining & Mould

摘　　要：研究了模具钢Cr12在电火花线切割加工中的脉冲宽度、开路电压、走丝速度及工作介质压力等参数对加工速度和表面粗糙度的影响。实验表明:随着脉冲宽度、开路电压、走丝速度及工作介质压力的增加,加工速度都随之增加;随着脉冲宽度、开路电压、走丝速度的增加,工件表面粗糙度值也随之增加,而工作介质压力的增加则能改善表面粗糙度。根据加工速度和表面粗糙度随切削参数的变化作了回归分析,为电火花线切割加工提供了可借鉴的经验公式。The influence of electric parameters like pulse width, open circuit voltage, wire speed and dielectric fluid pressure in WEDM for tool steel Crl2 was investigated. Experiments show that, with the pulse width, the open circuit voltage, wire speed, and dielectric fluid pressure increases, the cutting speed increases. With the pulse width, the open circuit voltage, wire speed increases, the surface roughness also will be increase; while the increase in the cutting fluid pressure can reduce the surface roughness. By changes of the cutting speed and the surface roughness, regression analysis is car- ried out and it provided for the experience formula for the wire cutting.

关 键 词：模具钢 电火花线切割加工 脉冲参数 工艺研究 回归分析 

分 类 号：TG661[金属学及工艺—金属切削加工及机床]