检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]重庆邮电大学光电工程学院检测电路与信息传输系统研究中心
出 处:《电子测试》2012年第4期9-13,共5页Electronic Test
摘 要:高阶正交幅度调制(QAM)系统中,随着QAM信号阶数的提高,频偏和相偏对系统解调性能的影响越敏感,其对同步性能的要求也越来越高。因此,必须在接收端对系统中的频偏和相偏进行更精确的补偿,使得接收端与发送端的载波信号达到同频同相,来提高解调系统的性能。本文首先简单介绍了两种常用两种面向判决的载波相位恢复算法,并利用MATLAB/Simulink为该算法搭建了系统仿真模型进行分析,然后给出了具体的实现方法并对其性能进行了分析。仿真结果表明,面向判决的载波恢复算法实现简单,稳态时抖动较小,非常适用于高阶QAM解调系统。In the high order quadrature amplitude modulation ( QAM ) system, with the QAM signal order increases, the effect of the frequency offset and phase offset on the demodulation system performance get more bitter, and the synchronization performance requirements are also getting higher. Therefore, we must compensate the system frequency offset and phase offset more precise on the receiver to made the carrier signal of the receiver and sender be the same frequency and phase to improve the performance of demodulation system. This paper firstly introduces two kinds of commonly used Decision Directed (DD) carrier phase recovery algorithm, then use MATLAB/Simulink to build the simulation model of the system to analyze the algorithm, final/y, the concrete realization method and its performance analysis is given. Simulation results show that the DD algorithm is simple and smaller jitter for steady state, fit for high-order QAM demodulation system.
关 键 词:正交幅度调制 载波恢复 判决反馈环 频偏相偏补偿
分 类 号:TN763[电子电信—电路与系统]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.7