检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:卢彦雷[1] 樊亚军[1] 石磊[1] 王俊杰[1] 夏文锋
机构地区:[1]西北核技术研究所,西安710024
出 处:《强激光与粒子束》2012年第4期975-979,共5页High Power Laser and Particle Beams
摘 要:结合GW级纳秒脉冲源建立了实验平台,研究了激光触发开关的延迟时间及其抖动与激光能量、工作电压、激光波长、透镜焦距等参数的关系。结果表明:开关延迟与抖动随激光脉冲能量的上升、工作电压的上升而逐渐减小;采用紫外光得到的开关延迟与抖动小于相同条件下红外光得到的结果;在高气压小间隙开关条件下,采用小的透镜焦距可以得到更小的开关延迟与抖动。开关在自击穿电压220kV、欠压比为80%、采用7mJ,266nm波长激光时的抖动为0.3ns,在此条件下进行了两台脉冲源的同步实验,得到其同步偏差85%置信率小于0.3ns。Based on the experiment platform with ultra-wide spectrum pulse source of GW level,the thesis investigates the influence on the delay time and jitter of laser-triggered switch of some relative parameters,such as laser pulse energy,laser wavelength,working voltage,and focal length of lens.The experimental results show that,the delay time of the switch decreases gradually as the laser energy or the working voltage increases.When 266 nm laser is adopted,smaller jitter can be achieved than using 1 064 nm laser.On condition of high pressure and small switch gap,the use of lens with smaller focal length shortens the delay time.The jitter is less than 0.3 ns while the self-breakdown voltage is 220 kV,the working ratio is larger than 80% and the energy of the 266 nm laser pulse is 7 mJ.In this condition,the synchronization experiment of two GW-level pulse sources is carried out and the synchronization difference is below 0.3 ns at the probability of 85%.
关 键 词:激光触发开关 气体开关 低抖动 GW级纳秒脉冲源
分 类 号:TM853[电气工程—高电压与绝缘技术]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222