两种生产工艺对H65黄铜管组织与性能的影响  

Influences of Two Kinds of Manufacturing Processes on Structures and Properties of H65 Brass Tubes

作　　者：雷玉霞[1] 林高用[1] 周玉雄[1] 王宏 张胜华[1] 

机构地区：[1]中南大学材料科学与工程学院,有色金属材料科学与工程教育部重点实验室,湖南长沙410083 [2]江苏太仓市金鑫铜管有限公司,江苏苏州215412

出　　处：《材料科学与工程学报》2012年第3期413-418,共6页Journal of Materials Science and Engineering

基　　金：国家十一五科技支撑计划资助项目(2009BAE71B04)

摘　　要：对挤压法和"连铸-冷轧"法两种工艺生产的H65黄铜管的组织与性能进行了综合对比研究。结果表明:两种工艺下H65黄铜管成品平均晶粒尺寸相差较小,挤压法工艺约14μm,"连铸-冷轧"法工艺约18μm;"连铸-冷轧"法成品管抗拉强度为335MPa,伸长率为61%,硬度为84.7HV1.0,挤压法成品管分别为360MPa,67.5%和82.6HV1.0,均达国标要求;挤压法成品管平均偏心率约12.5%,而"连铸-冷轧"法成品管偏心率仅为6.2%,且综合成材率较挤压法提高了11%。分析表明,高效短流程的"连铸-冷轧"法H65黄铜管加工工艺具有良好的发展前景。Microstructure and properties of H65 brass tubes which were manufactured by continuous casting and cold rolling（CCR） process and extrusion process were studied and compared comprehensively.The results show that H65 brass tubes manufactured through these processes have the similar grain size.Average grain size of products by extrusion process is about 14μm,while products by CCR process is about 18μm.Products of CCR process have great mechanical properties for its σb reaches 335MPa,δ approaches 61%,hardness is 84.7HV1.0,so as the product of extrusion process,the tensile strength,elongation and hardness reach 360 MPa,67.5% and 82.6HV1.0,respectively.They all have reached the national standard.Average eccentricity of product by extrusion process is 12.5%.However,the average eccentricity of products by CCR process is only 6.2%,its finished product rate increased by 11% compared with extrusion process.The CCR process of H65 brass manufacturing method with a short process and high efficiency has good prospects for development.

关 键 词：H65黄铜管 “连铸-冷轧”法 挤压法 组织与性能 

分 类 号：TG146.13[一般工业技术—材料科学与工程]