U-Mo合金γ相稳定性研究  

Study of γ Phase Stability of U-Mo Alloys

作　　者：尹邦跃[1] 屈哲昊[1] 

机构地区：[1]中国原子能科学研究院反应堆工程研究设计所,北京102413

出　　处：《原子能科学技术》2012年第5期596-602,共7页Atomic Energy Science and Technology

摘　　要：研究了U-Mo、U-Mo-X(X=Ti、V、Si)合金及U-Mo/Al、U-Mo-X/Al扩散偶界面层的γ相稳定性,探讨了合金元素和退火工艺对γ相稳定性的影响。结果表明:Mo含量越高,U-Mo合金的γ相稳定性就越高;U-6.5Mo-0.5Si合金的γ相稳定性较高,是因为U-Si混合焓较低,但加入Si易导致形成USix脆性相;而U-6.5Mo-0.5Ti和U-6.5Mo-0.5V合金的γ相稳定性较差,是因为Mo在Ti、V体系内具有较低的混合焓,易形成固溶体或金属间化合物,导致γ相贫Mo;随着退火温度从500℃升高至600℃,γ相发生共析分解,扩散层的γ相数量减少,α相增多,α相成为Al的快速扩散通道,促使形成UAl4、UMo2Al20和U6Mo4Al43等富Al相。The stability of γ phase of U-Mo and U-Mo-X（X=Ti,V,Si） alloys,diffusion couples of U-Mo/Al and U-Mo-X/Al was studied,and effects of alloying elements and annealing process on γ phase stability were investigated.The higher Mo content is,the more stable γ phase is.The γ phase of U-6.5Mo-0.5Si alloy is stable because the mixture enthalpy of U-Si is low,but Si addition into U-Mo alloy leads to formation of brittle phase USix.The γ phase of U-6.5Mo-0.5Ti or U-6.5Mo-0.5V alloys is unstable because the mixture enthalpy of Mo-Ti or Mo-V is low,and this leads to formation of solid solution or compounds and Mo dilution in γ phase.As annealing temperature increasing from 500 ℃ to 600 ℃,γ phase decreases by eutectoid decomposition,α phase increases,and some new Al-rich phases such as UAl4,UMo2Al20 and U6Mo4Al43 are produced.

关 键 词：U-MO合金 Γ相 退火 相变 扩散偶 

分 类 号：TL352.21[核科学技术—核技术及应用]